First step: install the supports for the (pet tent) on your paddle board.

Second step: adjust the elastic cords of the pet tent according to your designated paddle board (included with purchase). Note: do not overtighten the elastic cords on the paddle board accessory mounts.

This is an example of the knots you need to make!

Third step: Install the support rods for the pet tent canopy onto the mounts, then attach the pet tent canopy to the four designated rods. Note that the height of the tent can be adjusted according to your personal paddle by using the extensions on the rods provided for this purpose.

Fourth step: Install the parts as shown in the photo below at the ends of the pet tent rods. In the photo, the one on the left goes towards the front (lowest point), and the one on the right goes towards the back (highest point) of the pet tent.

Fifth step: Attach the canopy to the supports using the holes provided for this purpose. It is also possible to attach the "paddle board table" to the designated mount using the holes located at the corners of the table and on the supports.

Also ensure you attach the elastic cord to the four corners of the canopy in the designated holes on the supports!

The height and width can be adjusted using the rods provided for this purpose.